Forum

 

CR10 Smart screen l...
 
Notifications
Clear all

CR10 Smart screen locks up after starting cloud print


Doggington
Posts: 1
Registered
Topic starter
(@doggington)
New Member
Joined: 8 months ago

Hi,

On the current firmware (as of 18/11/21) for both the screen and the board, if you send a print to the CR-10 Smart via creality cloud the screen updates hotend & bed temperature but percentage complete, time remaining and time elapsed does not update

Further, the screen recognises input (it beeps) but you can't actually interact with anything except stop/cancel print which pops up the confirmation prompt as normal but doesn't actually cancel the print (Cancelling by creality cloud works though).

Thanks

Reply