CP-01 printer prints without removing the filament
I have a similar problem with the CP-01.
Usually it stops 2 -4 % through a print, with about 1.5mm of layers on the bed I tried different files , same issue.
It seems a common problem, with a few suggested solutions.
Currently I’m trying a print with :
A change from Marlin G Code to Makerbot G Code.
Cooling Fan off.
210C extruder with PLA
50C hotplate , untill 3-4mm is built then manually turned down to room temp.
A tighter filament securing screw ( on the front of the extruder)
So far I have about 7mm of build on the hotplate,my best result so far.
I fear this 3D printer will end up just as a laser engraver.
Glad it was on sale.