Forum

 

Notifications
Clear all

[Sticky] using G92 position command


Ted5855
(@ted5855)
New Member Registered
Joined: 2 months ago
Posts: 1
Topic starter  

has anyone tried to use G92 for the Z offset on the BLT. I have to put -1.02 in the Z after it homes the Z axes. I would like to have it in the start of the program. I have tried to put it in at the start, before the two lines and right at the start of the print. Could it be that it thinks Z is going below the build plate?

 


ReplyQuote