Forum

 

Forums
Members
YvonH
Activity
 
Notifications
Clear all
YvonH
YvonH
Group: Registered
Joined: 2021-03-07
Active Member Registered
1
Profile Activity
@seackone Another suggestion discussed (about page 19 to 23...

In forum Ender 3 V2

 1 year ago
Hi all, Here are more test results. Two weeks ago, I gro...

In forum Ender 3 V2

 1 year ago
Hi, It might vary depending of the printer and control boa...

In forum Ender 3 V2

 1 year ago
Hi all, Just received a new 4.2.2 control board yesterday....

In forum Ender 3 V2

 1 year ago
In my case, the 3D printer is in a corner in my workshop and...

In forum Ender 3 V2

 1 year ago
If you hear knocking noise, this might means there is someth...

In forum Ender 3 V2

 1 year ago
Yesterday, after my last test, I took apart the control boar...

In forum Ender 3 V2

 1 year ago
Hi all, I got some interesting results. First here is my...

In forum Ender 3 V2

 1 year ago
Grounding stepper motors is not a bad idea no matter what. ...

In forum Ender 3 V2

 1 year ago
I digged into the marlin's config examples but I cannot find...

In forum Ender 3 V2

 1 year ago
Thanks for the update. At this point, it really looks like ...

In forum Ender 3 V2

 1 year ago
I tried another print job this morning with the same setting...

In forum Ender 3 V2

 1 year ago
Here is a summary of what I did and the results so far: I ...

In forum Ender 3 V2

 1 year ago
I just adjusted the voltages as follow. I decided not to to...

In forum Ender 3 V2

 1 year ago
Would changing Z and E have any effect on the layer shifting...

In forum Ender 3 V2

 1 year ago
Page 1 / 2