Forum

 

Forums
Members
tundrwd
Activity
 
Notifications
Clear all
tundrwd
tundrwd
Group: Registered
Joined: 2021-03-04
Eminent Member Registered
2
Profile Activity
New Hot end to deal with temps over 220C and 6 hour prints?

In forum TroubleShooting(Printing Help)

 9 months ago
Cura - Pause at Height problem

In forum How-to & Troubleshooting

 1 year ago
One thing - did you "save" the settings for the BLTouch afte...

In forum Ender-3 Series

 1 year ago
Philips screws about to fall out of z-axis motor?!?

In forum Ender-3 Series

 1 year ago
Don't know about your issue - but I had massive layer shifts...

In forum Ender 3 V2

 1 year ago
I've had the same thing - and power gets bad at my location ...

In forum Ender 3 V2

 1 year ago
This! I had the same problem couple days ago. Had to renam...

In forum Ender 3 V2

 1 year ago
@kevin I agree - plus less clean up afterwards. Sorry - I...

In forum Firmware/Software Help

 1 year ago
Cura plugin to "test fit" model to use the least amount of f...

In forum Firmware/Software Help

 1 year ago
Extruder works fine. I can immediately shift to another PLA...

In forum TroubleShooting(Printing Help)

 1 year ago
Problems printing with iSANMATE 80/20 PLA+/Wood filament

In forum TroubleShooting(Printing Help)

 1 year ago
Print stops - randomly

In forum TroubleShooting(Printing Help)

 1 year ago
Another thing - is your print shifting on your bed - or is t...

In forum Ender 3 V2

 1 year ago
@kikko - have you checked belt tension, etc.? My 4.2.2 boar...

In forum Ender 3 V2

 1 year ago
@hantuuk - I got a 4.2.7 board, and even without using the g...

In forum Ender 3 V2

 1 year ago
Page 1 / 3