Forums
Members
校工叔叔(Mr. Au)
Activity
 
Notifications
Clear all
校工叔叔(Mr. Au)
校工叔叔(Mr. Au)
Group: Registered
Joined: 2020-10-27
Eminent Member Registered
2
Profile Activity
Sharing my similar story. I have 2 machines that the nuts w...

In forum How-to & Troubleshooting

 1 day ago
It looks like to me that the right side of the bed is perfec...

In forum How-to & Troubleshooting

 1 day ago
My concern about Ender 7 is the nozzle. It said one of the ...

In forum Ender 7

 1 day ago
I don't think Creality will sell just that plastic connector...

In forum TroubleShooting(Printing Help)

 1 month ago
Try to do it from the nozzle if the pneumatic joint is clipp...

In forum CR-6 SE

 2 months ago
I do this with just a piece of tape.  Untitled.pn...

In forum CR-6 SE

 2 months ago
I did have the same problem at my school's Ender 3 Pro. Li...

In forum General Discussion/Announcement

 2 months ago
I am not aware of such plugin, but there are tons of plugins...

In forum Firmware/Software Help

 2 months ago
I miss the point where you said wood filament on your origin...

In forum TroubleShooting(Printing Help)

 2 months ago
I will try re-seat the bowden tube to make sure there's no g...

In forum TroubleShooting(Printing Help)

 2 months ago
Sounds like wrong voltage to me. Creality printer set defau...

In forum TroubleShooting(Printing Help)

 2 months ago
How are you doing your print? SD card? Octoprint? or Wifi bo...

In forum Ender 5 Plus

 2 months ago
The law of nature, object expand when something is hot. Do ...

In forum CR-10S Pro

 2 months ago
While it's good that you got your problem fixed. Your setup...

In forum TroubleShooting(Printing Help)

 2 months ago
unless your object is very small, printing ABS require enclo...

In forum Ender 6

 2 months ago
Page 1 / 3
Scroll Up