Notifications
Clear all
Eli liu
Eli liu
Group: Registered
Joined: 2020-09-10
Reputable Member Registered
5
Issue 1:warped bed. You need to find out how badly the bed w...

In forum How-to & Troubleshooting

4 months ago
@schmerzlich Thanks a lot, I will deliver your message to th...

In forum CR-6 SE

4 months ago
@monoxid09 check out this video

In forum Ender-3 Series

4 months ago
@aliyanna have you tried any other models like the XYZ cube....

In forum Ender 5&5pro

4 months ago
There's another option called something like "refresh the sd...

In forum How-to & Troubleshooting

4 months ago
There's another option called something like "refresh the sd...

In forum How-to & Troubleshooting

4 months ago
This video may help.

In forum Ender-3 Series

4 months ago
@railchaser2020 From your description seems like the printer...

In forum Ender-3 Series

4 months ago
Interesting phenomenon. If the model and slicing settings ar...

In forum Ender 5&5pro

4 months ago
It depends on which firmware you are flashing. A long beepin...

In forum Ender 3 V2

4 months ago
Did you pause the printer manually or by using the Pause at ...

In forum How-to & Troubleshooting

4 months ago
From the image, it has a similar heat block to the ender pri...

In forum Other CR Series

4 months ago
@markus-doderus We usually update the firmware when we add a...

In forum Ender 5&5pro

4 months ago
Preheat the nozzle to 190c, press the extruder clamp, and fe...

In forum How-to & Troubleshooting

4 months ago
Not a critical problem but happens sometimes. The reason i...

In forum Ender-3 Series

4 months ago
Page 1 / 31