Creality 3D Resource Forum

Notifications

Clear all

3nderUser

Group: Registered

Joined: 2021-01-10

Extruder Registered

	@michielper Yes that's for slicing objects. It divides a so... In forum Ender-3 Series	2 hours ago
	Meshmixer 👍 In forum Ender-3 Series	22 hours ago
	Yes E-steps.. Steps per mm in movement settings on printer. ... In forum Ender 3 V2	4 days ago
	That's normal because settings for stepper are different ste... In forum Ender 3 V2	4 days ago
	@john Reading this solution (edit 2) I would check the cabl... In forum Ender 3 V2	4 days ago
	@john So you mean extruder motor is ok? Can also move the b... In forum Ender 3 V2	4 days ago
	@john Switch the extruder cable with cable from Z-stepper, m... In forum Ender 3 V2	4 days ago
	@hantuuk Installing 4.2.7 board solved all layer shift issue... In forum Ender 3 V2	5 days ago
	Under extrusion. Calibrate your E-steps. In forum Ender 3 V2	1 week ago
	@meltdown Yes, that's how it goes.. Set your Z-offset to -2... In forum Ender-3 Series	1 week ago
	@christ49fr Hi.. With sharp knife lift plastic lip you can... In forum Ender-3 Series	1 week ago
	@clh Maybe check the screw that is holding the extruder lev... In forum Ender-3 Series	1 week ago
	Yes, temperature settings are done in slicer, it's unusual t... In forum TroubleShooting(Printing Help)	1 week ago
	@vpersiani Good to see progress in your print 😊 What slic... In forum TroubleShooting(Printing Help)	1 week ago
	@tundrwd Well, it's just a hobby and many upgrades are real ... In forum Ender 3 V2	1 week ago

Page 1 / 8 Next

Forum Statistics

24 Forums

951 Topics

4,255 Posts

0 Online

4,258 Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed